LTC 40
LTC 40 is a cutting line with rotating knives
for tube diameters from ø12 to ø40. With this
system the cut tube is swarfless and with no
burrs on the outside, with a low tooling cost.
Tube clamping is carried out by an easily
interchangeable collet. The discharge unit is
available in various lengths according to
customer's cutting requirements and is complete
with a selection device for rapid discharge of
cut tubes and scrap. Bar-stops are easy to
adjust and have been accurately designed to
avoid damage caused by blows from tubes.Machine
control is a microprocessor with capacity for
memorising 99 programmes to manage bar feeding,
machine logic and diagnostics. Simplicity of
programming guarantee ease of use for operator.
